Contact Us

Tel:+86-571-63702298

Fax:+86-571-63704882

Mob:+8613738019896

E-mail: econxu@zhengchida.com

Add:No.188 ,Xinxi Road, Jincheng Street, Lin'an City, Zhejiang P.R.C City: Lin'an Hangzhou

Home > News > Content
Mower Blade Research Is Moving In The Direction Of High Speed And Energy Saving Aug 03, 2017

Mower Blade also called from the weeding machine, lawn machine, 1805 years there, when the lawn Mower Blade is human, no power support. In 1805 the British Pramakette invented the first harvest of grain and can cut the weeds of the machine, by the people to promote the machine, through the gear drive to spin knives, which is the prototype of the lawn Mower Blade. 1830 British textile engineer Bill - Pudding made a lawn lawn Mower Blade patent.

The modern lawn Mower Blade consists of a cutterhead, an engine, a walking wheel, a walking mechanism, a blade, a handrail and a control part. It is composed of parallel four-pole lifting device, frame, left and right wing weeding device, whole machine deviation device, comb tooth rotary bevel gear speed transmission mechanism and comb tooth type deepening device; efficiency is higher than artificial weeding 8 to 10 times, widely used for pruning lawn, vegetation and so on. Mower Blade has a diesel engine and gasoline engine, the blade using the engine's high-speed rotation output speed greatly improved, saving the herbivorous workers operating time, reducing a lot of human resources. The research of new lawn Mower Blade is developing in the direction of high speed and energy saving.

How to use Mower Blades and maintenance properly?

1. Mower Blade before mowing, you must first remove the debris in the mowing area, so as not to damage the grass head, blade. Lift state start the engine, you should first close the damper, start and then open the damper. If the turf area is too large, the Mower Blade is not allowed to work for more than 4 hours.

3. Before using the lawn Mower Blade, check the oil level to see if it is between the upper and lower scales of the oil scale. 5 hours after the use of new machines should be replaced with oil, the use of 10 hours after the oil should be replaced once again, according to the requirements of the manual after the regular replacement of oil. Replace the oil should be in the engine in a heat state. Filling the oil can not be too much, otherwise there will be: black smoke, lack of power (cylinder coke too much, spark plug gap small). Engine overheating and so on. Filling the oil can not be too little, otherwise it will be the engine gear noise, piston ring to accelerate wear and damage, and even the current tile and other phenomena, resulting in serious damage to the engine.

4. Maintenance of the air filter Before and after use, check whether the air filter is dirty and should be cleaned. If too dirty will lead to the engine difficult to start, black smoke, lack of power. If the filter is a sponge, can be cleaned with gasoline, the appropriate filter on the filter some oil, so that the filter to keep the wet state, but also to the filter element is paper, can remove the filter, dust off attached to the dust; Is conducive to adsorption of dust.